Blade Strop Prototype
This is a prototype of a strop for maintaining a knife's cutting edge. I got the idea sometime in the summer, and I realized it in the fall. It is not meant for removing a lot of material, only for finishing sharpening done on coarser stones, or for maintaining the edge of a knife that is still sharp but is starting to have trouble with tomatoes

It is just a board with a handle. It has a ceramic plate on one side, and a strip of leather with polishing paste on the other.


The handle has an indentation for a thumb on both sides. The basic idea is to hold the handle with the thumb in the indentation and rest the end of the strop on the edge of a table for stability. The ceramics side has a small peg from horn for finger protection. For sharpening on the ceramics side, the blade moves in the cutting direction, and a slip-up might happen.


To sharpen on the ceramics side, it's necessary to first wet the ceramics with a few drops of non-drying oil (glycerine, rapeseed, olive). For the sharpening itself, put the base of the knife on the end of the strop at the desired angle to the central plane of the blade (for my kitchen knives, 15°) and, with modest pressure, drag it across in the cutting direction in such a way that the whole length up to the tip is sharpened, if possible. For longer blades, it is possible to do this in more steps, but for best results, there should be as few as possible. After one side stroke, the knife needs to be flipped and the same stroke done in the other direction. Depending on the state of the blade, this has to be repeated multiple times. Be careful not to run over the corner of the ceramic plate with the blade. It won't destroy the knife, but it will leave an ugly scratch.
Oil and the ceramic plate will turn grey when doing this. That shows that it is removing material. After the sharpening is finished, it needs to be cleaned. First with oil, subsequently with detergent and water.


The process is similar on the leather side, but with two major differences. The blade moves in the opposite direction – dragging the back side first, like when spreading butter on toast, and at a right angle to the blade. To cover the whole blade, this has to be repeated several times in both directions. This step removes almost no material; it mainly straightens the microscopic bending of the edge.
With a bit of practice, it should be possible to maintain the edge of a knife for a significant time before it becomes necessary to remove more material with a coarser stone. But since this is a prototype, that assertion is currently being tested.
